ICHIBA Version II Hubcentric Wheel Spacers 15mm Mazda / Mitsubishi (5:114.3 / 67.1 Bore / 12x1.5 Thread Type) Boost Sensor Tap the N1 exhaust system pairs

the N1 exhaust system pairs a straight through design racing muffler with free flowing

Large 76mm (3”) piping is carefully routed through a large resonator in the mid-pipe and round the rear differential to a centralized Y-section for more even flow

Brake Line Kit Needed: 220-8307

The box is fully modular and adapts to our Ram Air Scoop (EVO15069) or our Snorkel (EVO15070)

The URs adaptively handle varying degrees of extreme heat and cold as consistently as they fare under temperamental

ICHIBA Version II Hubcentric Wheel Spacers 15mm Mazda / Mitsubishi (5:114.3 / 67.1 Bore / 12x1.5 Thread Type) Boost Sensor Tap the N1 exhaust system pairsVersion II wheel spacers are made from Aluminum Magnesium alloy. They are incredibly strong and very lightweight. Every spacer is a two piece design with pressed studs. Spacers bolts onto the existing studs. These are hubcentric spacers that is vehicle specific; will fit onto your vehicle's original hub perfectly without any gap. Wheel spacers move the wheel out from the hub, effectively widening the stance of the vehicle and lowering its roll center.